By default, Android scans for nearby Wi-Fi networks every 15 seconds when you have Wi-Fi enabled. This helps when you’re moving around between multiple access points, but for the most part, the high interval only serves to drain your battery. If you’d rather have your phone or tablet wait for 5 minutes before it looks for nearby Wi-Fi networks again. However, don't worry much because this problem of yours has come to an end, all you need is to follow the below steps.
DISCLAIMER: AndroBliz should not be held responsible for any damage or harm you got in your Android device (Brick).
IMPORTANT: Ensure total backup of your Data/ROM before proceeding or commencing with the steps below…
Wifi.supplicant_scan_interval
Note: These codes must be searched one after the other to avoid putting your device to more damage. Also be vigilant in case if what you're searching for pops up, then click on it to avoid more time waste.
After you must have located the above codes, fill them up or replace them with the below codes (if possible).
Wifi.supplicant_scan_interval=300
That'll be all for now, stay updated to AndroBliz for more enticing programs. For any question, suggestions, help/guide make use of the comment box below.
Thanks for reading my news about How to Increase Wi-Fi Connection Time at my blog Mods Firmware if you want too share this article, please put the resource, and if you think this article is very usefully dont forget to bookmark this site with CTRL + D on your keyboard to web browser.